Use and maintenance of single mass connecting rod vibration conveyor


The vibrating conveyor is a continuous conveying machine that uses a vibrator to vibrate the material tank, so that the materials in the tank slide or throw in a certain direction. The vibration conveyor is mainly composed of a vibration exciter, a load-bearing tank, a main vibration spring and a frame. Except for some parts of the vibration excitation mechanism, there are few relative rotating parts. The material is transported in a projectile state in the vibrating conveyor, and the abrasion of the transport groove is small.

The single-body connecting rod vibration conveyor is suitable for power, coal, metallurgy, building materials, grain and other industries. It is used to complete the conveying process of powdery and granular materials, especially for fine powder materials that are difficult to convey, such as fly ash , Cement, charcoal powder, coal powder, emery, etc., from the storage bin or hopper, evenly or quantitatively delivered to the receiving device.

vibration conveyor

Eccentric Connecting Rod Vibration Conveyor
 Use and maintenance of single mass connecting rod vibration conveyor:

1. Trial run

After the installation and commissioning of the single-mass connecting rod vibrating conveyor, the continuous test operation with no load shall be carried out for not less than 8 hours. Pay attention to the change of conveyor amplitude, working current and noise during operation, and confirm that there is no abnormal phenomenon before it can be put into normal operation.

2. Productivity adjustment

The single-mass connecting rod vibration conveyor is a fixed-frequency fixed-amplitude vibration conveyor. If you need to adjust the productivity of the conveyor, you can adjust the opening of the silo gate to change the amount of feed or change the eccentric position of the drive device to achieve adjustment. The purpose of conveyor productivity.

3. Operation and Maintenance

During the use of the single-body connecting rod vibration conveyor, it is necessary to regularly add grease (No. 3 calcium-based grease) to the bearing housing of the driving mechanism and the connecting rod bearing. Refill every two weeks for continuous operation and refill once a month for discontinuous operation. Always check the tightening of each fastener, and replace the wearing parts (plate springs, Helical springs, rubber springs and fasteners). Pay attention to check the temperature rise (feel) of the bearing part of the drive mechanism. If an abnormal phenomenon is found, it must be stopped and checked immediately.

Vibration Conveyor

Leave a Reply

Your email address will not be published.