PSL300-18-6000 vibration conveyor


PSL300-18-6000 type fully balanced vibrating conveyor is a short-distance conveyor with a small width of the trough. It is designed to transport 18 tons per hour, and the maximum rated length is 5 meters. The width of the trough 0.3 meters.

Vibratory conveyor
PSL Fully Balanced Vibrating Conveyor


PSL300-18-6000 type fully balanced vibrating conveyor has a simple structure and is easy to install and maintain. It is suitable for long-distance and wide-groove conveying requirements. The working noise is less than 75dB (A).


Because the inertial force is well balanced, the inertial vibration force (dynamic load) transmitted to the foundation is very small;

When installed on the floor surface or steel structure bracket, it has the incomparable vibration reduction advantages of other types of vibration conveyors;

Install a screen in the conveying tank, and the single-way or double-layer conveying tank realizes the classification or separation of the materials while conveying the materials;

If the balance body is changed to a conveying trough, the upper and lower conveying troughs can be simultaneously conveyed in the opposite direction, and the use of two conveyors can be produced without increasing equipment and space;

For high-temperature materials that need to be conveyed, the particle size, corrosiveness, and relative hardness of the materials are not limited. Depending on the material being conveyed, stainless steel plates or composite materials can be used;

Drying, cooling, sorting, and drainage processes can be performed simultaneously, making this transfer process an extremely efficient transfer method;

Rotating, swinging, friction, consumption and other parts require little injection of lubricant and low failure rate. Maintenance is very easy.


PSL300-18-6000 type fully balanced vibrating conveyor
ModelConveying capacity (T / H)Conveying trough width (mm)Conveying trough length (mm)Motor power (Kw)
Remarks:1. The calculation of the transportation volume is calculated according to the horizontal transportation of river sand (heap density 1.6t/m3, water content 5%).2. The power of the tank body should be recalculated when installing the sealing cover, the lining plate and conveying the materials of different bulk density.3. When the conveying distance exceeds 15 meters, the segmented structure is adopted, and the site is assembled and connected.4.For the explanation of model PSL300-18-6000, the first number refers to the slot width, the second number refers to the conveying capacity, and the third number refers to the slot length.


PSL300-18-6000 type fully balanced vibrating conveyor has simple structure, few lubricating parts, convenient installation and adjustment, low maintenance workload, low energy consumption, safe operation and easy automation control.

Balanced vibratory conveyor
PSL Balanced Vibrating Conveyor


PSL300-18-6000 type fully balanced vibrating conveyor is suitable for long distance and wide slot width conveying requirements, widely used in recycling, pellet manufacturing, sawmill, plywood, OSB, food processing and agriculture industries.


During the use of the vibrating conveyor, it is necessary to regularly apply grease (No. 3 calcium-based grease) to the bearing housing and the connecting rod bearing of the drive mechanism.

Continuous operation is repeated every two weeks, and non-continuous operation is filled once a month.

Always check the fastening of each fastener and replace consumables (plate springs, coil springs, rubber springs and fasteners) for long-term damage (fatigue, defects, aging wear).

It is strictly forbidden to operate with illness.

Pay attention to check the temperature rise (feel) of the bearing part of the drive mechanism

If an abnormality is found, it must be stopped immediately for inspection.

Vibration Conveyor

Leave a Reply

Your email address will not be published.