Common faults and treatment
Vibration conveyor body without vibration
Check the vibration motor wiring and connect the power cord; check whether the vibration motor is in good condition and replace it if it is damaged.
No amplitude display
The body of the vibrating conveyor vibrates, the material does not run, and the amplitude indicator has no amplitude display. The reason is that the wiring of the two vibration motors runs in the same direction. Swap the two-phase power wiring for one of the vibration motors.
The vibrating conveyor operates abnormally
Normal noise should be less than 80 decibels. Check and tighten the vibration motor mounting bolts and other fastener bolts; the vibrating feeder contacts and collides with the surrounding equipment and objects, adjust the installation of the feeder body to ensure the distance between the feeder body and surrounding equipment and objects The gap is not less than 30-50mm.
The motor vibration conveyor oscillates left and right.
The spring force of the shock absorber is uneven, and the shock absorber spring is selected to make the spring force corresponding to the front and rear springs basically the same; the excitation force of the two vibration motors is inconsistent, open the end covers at both ends of the vibration motor, check and adjust the angle of the eccentric block, Ensure that the excitation force of the two vibration motors is the same.